In the sheet metal forming industry, finite element (FE) simulation is an important tool for fabricators predicting metal flow, optimizing geometry, and selecting process variables before developing new dies. The accuracy of the simulation results depends highly on the accuracy of the input parameters and the boundary conditions used in the FE model. Input data includes the mechanical and thermal properties of the material, die geometry, forces, degrees of freedom, coefficient of friction, and ram speed.

One material property that affects simulation results significantly is flow stress (true stress/true strain curve) of the material. Flow stress determines the behavior of the material during the plastic deformation. Currently two methods are used for determining flow stress data: tensile test and bulge test.

Tensile Test

The tensile test is a standard test for determining the elastic and plastic behavior of material under a uniaxial tensile condition. In the tensile test, a metal bar undergoes uniaxial tension up to fracture. The test can be used to determine such material properties as flow stress data, Young’s modulus, yield stress, ultimate tensile stress, uniform elongation, total elongation, and Lankford coefficient (r-value) .

There are some limitations when using a tensile test to determine flow stress. The tensile test is a uniaxial tension test, so it provides the material behavior in uniaxial strain path. Also, the strain value at necking obtained from this test is small.

In contrast, in real sheet metal forming processes such as bending and deep drawing, materials deform in a different strain path, ranging from pure shear to biaxial tension. Also, the maximum true strain before fracture observed in the real stamping process is higher than what is obtained from the tensile test.

Therefore, in the simulation of processes such as deep drawing or bending, extrapolation of the flow stress data is required to determine the behavior of the material for the strain values higher than what is obtained from the tensile test.

Bulge Test

The hydraulic bulge test is used to evaluate formability and determine the flow stress data of the material. The stress state in the hydraulic bulge test is biaxial; therefore, this test can provide the flow stress data for higher strain values without localized necking compared to a uniaxial tensile test. The Center for Precision Forming (CPF) has used a viscous medium instead of hydraulic fluid, which reduces the complexity of the test and improves sealing.

The pressure for forming the material and the dome height are measured simultaneously during the viscous pressure bulge test . The true stress/true strain data then can be calculated using the inverse analysis method and database created from the FE simulation.

For large strain values, the flow stress data obtained from the bulge test is more accurate than extrapolation of the tensile test results. Consequently, the simulation results should be more accurate when using flow stress data from the bulge test compared to the tensile test.

The bulge test cannot provide flow stress data for low strain values close to the yield point , so when the data is used in simulation, the yield point of the material isn’t defined accurately. This can affect the elastic behavior of the material in the simulation and cause inaccurate simulation results, especially when springback must be predicted.

中国最大钣金展-锻压展-2016第十七届广州国际钣金、锻压工业展览会-巨浪展览- -The 17th China（Guangzhou）Int’l Sheetmetal machinery, Forging, Stamping and Setting Equipment Exhibition