Home AboutUs Exhibition
Info
News
Center
Exhibitor
Manual
Cost of
Participation
Floor
Plan
Exhibition
Retrospect
Media
Support
Contact Chinese
 News Type
Exhibition News
Industry News
Company News
Media reports
 New Detail
     
Steel will remain a critical component for automakers, says the AISI’s Thomas Gibson-The 20th China (Guangzhou)Int’l Fastener & Equipment Exhibition
11/6/2018  紧固件展-紧固件采购会-国际紧固件展-fastener expo
---------------------------------------------------------------------------------------------------------------
    

The American Iron and Steel Institute''s president and CEO Thomas J Gibson, has filed comments with the US Environmental Protection Agency (EPA) and the National Highway Traffic Safety Administration (NHTSA) on the the Safer Affordable Fuel-Efficient (SAFE) Vehicles Proposed Rule for Model Years 2021 to 2026.

The AISI supports the general direction of the new proposal, claiming that it will establish a standard that balances the priorities of affordability, safety, jobs and the environment.

"We believe that steel will continue to be a critical component for automakers to meet the final requirements," Gibson said in his submission. "We are strong, advocates for one national programme of standards, as we believe this is best for automakers, the automotive supply chain including the steel industry, in addition to consumers and the economy as a whole."

According to Gibson, the AISI believes that an overly stringent standard that optimises tailpipe-only GHG emissions and fuel economy enhancements ''to the exclusion of other necessary and important design factors'' would result in ''negative outcomes'', highlighting increased costs to the consumer, negative effects on the environment, increased safety design challenges and a negative job impact. He also referenced the Steel Recycling Institute''s Life Cycle Greenhouse Gas Study of Automotive Lightweighting.

Gibson expressed concern above ''any outcomes that could force automakers into choosing alternative materials'' that are more costly and have the potential to result in higher overall GHG emissions compared to lightweighting with advanced high-strength steel.

In the automotive industry, there has been a kind of battle raging between the aluminium and steel industries over which is best for cars going forward, bearing in mind the introduction of Corporate Average Fuel Economy (CAFE) standards, which were first enacted by the United States Congress in 1975. It has been said recently that, within 15 years, there could be a nearly even split between steel, aluminium and carbon fibre in the average North American-produced light vehicle. However, the continuing development of advanced high steels and calls for a lifecycle assessment of the materials used in car manufacturing have prompted the development of the aforementioned SAFE regulations.

"Since 1970, the steel industry has developed more than 200 innovative new grades of steel, many in collaboration with automakers and specifically for the purposes of achieving new vehicle designs that meet regulatory requirements," Gibson said, adding that material selection is important in helping automakers achieve their performance goals ranging from the driver''s experience to passenger safety and overall durability. "These choices must all be balanced to meet the needs of the consumer at an affordable cost while protecting the environment," Gibson added.

紧固件展-2019第二十届广州国际紧固件及设备展览会-巨浪展览 -The 20th China (Guangzhou)Int’l Fastener & Equipment Exhibition - Fastener exhibition,2019 Fastener exhibition, China Fastener exhibition, Guangzhou Fastener exhibition, 2019 Fastener expo, China Fastener expo, Guangzhou Fastener expo

Copyright © 1996-2019  JULANG.COM.CN Stone Rich Sight. All Rights Reserved
Add:Room 3A05-3A06,Building A1,Xinghui Park,Huaming Road 29,Pearl River New City,Guangzhou,510623,China